Self Limiting Heat Cable - Self Limiting Cable - ELTRACE

DHB-103 DomoClick T derivation

DHB-103 DomoClick® T derivation set for  the junction between three heating tapes (for example for a T derivation or extending a circuit

• T derivation
• 2 terminals
• 3 heat-resistant ligatures
• 3 stirrups for wall mounting
• self-adhesive labels “electric supply” and “terminal”

Doing the job

• Box and cover in polyamid
• Ligature
• Incorporated electrical connection including cablegland PG 16 for DHB 100,  DHB 102 and DHB 104
• Stirrups for wall mounting  CE

Installation prescriptions

• The installation of bands, connections to DomoClick^® connectors to connection boxes will be carried out according to the rules of the trade.
• Before going ahead with work on electric tracers, care will be taken to isolate them from the mains.
• The DomoClick® connection and junction techniques are approved if used together with self-adjusting Eltrace heating tapes. Eltrace guarantees correct working only in relation with the mentions heating tapes.
• Through the direct mounting onto the pipe, DomoClick^® uses less heating tape.
• As a general rule, DomoClick^® is fixed to the pipe with the supplied ligatures. DomoClick^® can also be fixed to the wall with supplied stirrups.
• The supply cable is to bedirectly connected into the DomoClick^®. Any exterior supply, junction or derivation box is thus   avoided.
• In anti-frost installations for gutters, DomoClick® must not be installed in a gutter or on the roof, but in a sheltered position under the rroof or eave
• DomoClick® can be installed directly on pipes with a service temperature of less than 70°C. Short periods at 80°C are admitted. Important : for admitted temperatures of heating tapes, refer to the technical data
• DomoClick® incorporated into pipe insulation. All supply points, junctions and terminals must remain accessible. Electrical supply points and  terminals  must be indicated with the supplied self-adhesive labels.